Audio Innovate INNOFADER Custom VCA Crossfader Kit for Pioneer DJM800

This Item Has Been Discontinued
Or Is No Longer Available.

This information only remains here as a reference
for those who need information on this product.

audio innovate innodjm800
audio innovate innodjm800 Audio Innovate INNOFADER Custom VCA Crossfader Kit for Pioneer DJM800
This is everything you need to install an Audio Innovate INNOFADER into your Pioneer DJM-800 mixer!

This kit includes the following:
• 1 Audio Innovate INNOFADER-PNP crossfader
• The Pioneer DJM-800 crossfader adapter plate
• 2 screws

INSTALLATION INSTRUCTIONS:
The first step is to remove the crossfader. This is the piece that will come out.


The slot is covered by the plastic insulator as shown:


Now please do not cut a hole here. It will save lots of time, but it's impossible to return it back to its original state, which you might want to do if you ever sell it or send it back for repair.

So you need to take off the faceplate - 9 screws on the top, 2 screws in front, 2 screws in back. It is not necessary to remove the screws for the microphone. Only the gain knobs need to be removed. Lift the faceplate up then flip over to the left and you will see the insulator card. Remove the following 2 screws from the insulator card:


Then tuck the insulator card inside the unit. There should be a small space under the front panel where the insulator card can partially fold and tuck in. Tuck in the insulator card while reattaching the faceplate.

Hook up the Pioneer 3-pin crossfader connector to J13 also marked "NUMARK DIGITAL" on the Misc. Adapter Board as shown.
VERY IMPORTANT: Even though it fits perfectly, do NOT use the connector marked "UREI KORG". This connector has the power reversed. We have heard back from customers who have done this by accident and it pops a fuse in the DJM-800 which requires a service tech to replace!

Put insulator tape on the adapter board and Innofader just to make sure things don't short out. It is extremely important that you insulate the Innofader properly. If you are still unclear about how to properly insulate the Innofader after looking at the pictures, please see our insulating instructions. Insulated tubes are included with the Innofader kit.


Before putting everything back, tuck in the adapter cable visible from the slot.


Install the Innofader using the DJM-800 adapter plate and 2 screws included with it. You should use the included screws or else the crossfader plate will bulge! Make sure when you install the Innofader that the label is facing towards the line faders.

Additional Information

UPCN/A
SKUINNODJM800
ManufacturerAudio Innovate
Product ConditionNew - On Clearance
ReturnableNo

Write Your Own Review

You're reviewing: Audio Innovate INNOFADER Custom VCA Crossfader Kit for Pioneer DJM800

How do you rate this product? *

 1 star2 stars3 stars4 stars5 stars
Quality