for Instant VIP Discounts on most gear! (Better Than Codes, and it's Free)

Audio Innovate INNOFADER Professional VMC Crossfader for Pioneer DJM909/DJM707

Dropships Not In Stock, But We'll Order It In For You
Free Shipping FREE Ground Shipping to the contiguous U.S. (details)
VIP Price:

Non Returnable: This item is non-returnable unless defective. Additional restrictions may also apply. Details

audio innovate innodjm909
Images may show accessories or configurations not packaged with this item.

Be the first to review this product

This Innofader model is custom designed to work in the Pioneer DJM-707 and DJM-909. It has all of the same adjustments as the original Innofader, and comes with mounting hardware, a calibration board, and lube kit. No other adapters are required.

This is a simple installation - just mount to the adapter plate included in the kit and plug in the mixer cable - but make 100% sure that you tape the bottom of the Innofader DJM-909 prior to installation. If the Innofader accidentally touches them by accident, then this causes a fuse on the 5V supply to burn out.

Also note that Audio Innovate has found some issues with initial production models:
1) The extra long crossfader cable causes the Innofader to put out noise at the cut-in point. Please reduce the cable to about 6" in length to make it work properly if you have an extra long cable over 12" long.
2) The software is set up so that the cut-in point may move on its own. To fix this, you will need to set up the mixer for a soft mix curve on both sides of the fader. In addition, you will need to set the Innofader curve for a sharp curve or use an Innojuster if you want to use the Innofader for both cutting and mixing.

Additional Information

ManufacturerAudio Innovate
Product ConditionNew

Write Your Own Review

You're reviewing: Audio Innovate INNOFADER Professional VMC Crossfader for Pioneer DJM909/DJM707

How do you rate this product? *

 1 star2 stars3 stars4 stars5 stars