• 1300 Watts at 8 ohm Stereo
• 2200 Watts at 4 ohm Stereo
• 3250 Watts at 2 ohm Stereo
• 6500 Watts at 4 ohm Bridged
The Pro 200 Series professional power amplifiers offer Crest's renowned sonic integrity and can handle exceptionally high power ratings (4500 W bridged on the Pro 8200) in a compact, lightweight (25 lbs.) 2RU package. The Pro 200 Series amps also feature Automatic Clip Limiting (ACL) to protect connected drivers; IGM Impedance Sensing to accommodate varying impedance outputs; tunnel-cooled, high efficiency heat sinks; and variable-speed DC fans to limit the operating temperature and extend amplifier life.
TECHNICAL SPECIFICATIONS:• Minimum load impedance: 2 Ohms
• Maximum RMS voltage swing: 113 Volts
• Frequency response: 10 Hz - 100 kHz; +0, -3 dB at 1 Watt
• Power bandwidth: 10 Hz - 30 kHz; +0, -3 dB at rated 1000
• Slew rate: >10V/us
• Damping factor (8 Ohms):>300:1 @ 20 Hz - 1 kHz
• Phase response: +5 to -15 from 20 Hz to 20 kHz
• Input sensitivity (x 40): 2.35 Volts 3% for 4 Ohm rated power, 2 Volts
3% for 1 kHz 2 Ohm rated power
Input sensitivity (x 20)
4.7 Volts 3% for 4 Ohm rated power, 4 Volts
3% for 1 kHz 2 Ohm rated power
• Input impedance:
15 k Ohms, balanced
Current Draw @ 1/8 power
3,350 Watts @ 2 Ohms; 2,200 Watts @ 4 Ohms
Current Draw @ 1/3 power
7,300 Watts @ 2 Ohms, 5,000 Watts @ 4 Ohms
Cooling
• Two temperature dependant variable speed
80 mm high output DC fans
Controls
• Two front panel attenuators, rear panel mode
switch and gain select switch
Indicator LEDs
• 2 ACL (clip limiting), 2 signal presence,
• 2 DC protect, 2 temperature limit
Protection
• Thermal, DC, turn-on bursts, subsonic,
loads
• Connectors: XLR, Speakon and Binding Post speaker
• 120 Volt 30 amp mains, 240/230 Volt
IEC mains
• Construction: 16 ga. steel with 5 mm aluminum front
• Dimensions: 89 mm x 483 mm x 311 mm + 38 mm
• support ears and connectors: (3.5" x 19" x 12.25" + 1.5")
California Prop 65 -
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov