725W per channel into 8 ohm, 1150W per channel into 4 ohm, 1700W per channel into 2 ohm, cooling fan, short protection, data port, XLR and 1/4 in. inputs, MDP binding post outputs, 3 rack spaces, ONLY 30 lbs!
FEATURES:Stereo Mode (both channels driven)
• 8 ohms FTC 0.1% THD 20 Hz-20 kHz: 725W
• 8 ohms EIA 1.0% THD 1 kHz: 750W
• 4 ohms FTC 0.1% THD 20 Hz-20 kHz: 1150W
• 4 ohms EIA 1.0% THD 1 kHz: 1225W
• 2 ohms EIA 1.0% THD 1 kHz: 1700W
Bridge Mono Mode
• 8 ohms FTC 0.1% THD 20 Hz-20 kHz: 2300W
• 4 ohms EIA 1.0% THD 1 kHz: 3400W
• Distortion (SMPTE-IM): less 0.05%
• THD (Typical): 4 ohms to 8 ohms: 20 Hz-20 kHz,10 dB below rated power. 1.0 kHz and below, full rated power: 0.01%
• Damping Factor (1 kHz and below): greater 500
• Signal to Noise (20 Hz-20 kHz): 108 dB
• Input Sensitivity @ 8 ohms: 0.96 Vrms
• Voltage Gain: 80x (38 dB)
• Output Circuitry: H (3-Step)
• Cooling (rear to front airflow): Single Fan
• Height (1 RU=1.75 inches (4.45cm): 3 RU
• Weight (net): 30 lbs
• 120v Current Consumption(1/8 Power Pink Noise @ 4 ohms) Multiply current by 0.5 for 230V units: 11.5 A
• Connectors (each channel) Input: Neutrik Combo XLR plus 1/4inch TRS input and Barrier strip (eurostyle detachable headers on PL 6.0 and 9.0) Output: Touch-proof binding posts
• Frequency Response: 8 Hz-100 kHz, 0, -3 dB
• Input Impedance: 10 K ohms unbalanced, 20 K ohms balanced
• Amplifier Protection: Full short circuit, open circuit, thermal, ultrasonic and RF protection. Stable into reactive or mismatched loads.
• Controls: Front: AC switch, Ch 1 and Ch 2 gain knobs, Ch. 1 and Ch.2 clip limiter switches Rear: Parallel/Stereo/Bridge Switch, Remote AC Control terminal strip
• Load Protection: On/off muting, DC-fault power supply shutdown
• Power Requirements: 120, 230 VAC, 50-60 Hz
• Dimensions: 19.0 inch (48.3 cm) rack mounting 17.9 inch (45.5 cm) deep behind front mounting rails.
California Prop 65 -
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov