QSC USA900 Amplifier

FEATURES:
Stereo Mode (both channels driven)
• 8 ohms 20 Hz-20 kHz 0.01% THD: 240W
• 8 ohms 1 kHz 1% THD: 270W
• 4 ohms 1 kHz 1% THD: 450W
• 2 ohms 1 kHz 1% THD: 550W
Bridge Mono Mode
• 16 ohms 1 kHz 1% THD: 540W
• 8 ohms 1 kHz 1% THD: 900W
• Signal-to-noise (A weighted): 104 dB
• Input Sensitivity @ 8 ohms: 1.16 Vrms (3.5 dBu)
• Voltage Gain: 40x (32 dB)
• Cooling: 2-Speed Fan
• Weight: 34 lb
• Power Consumption: <9A
• Distortion (SMPTE-IM): Less than 0.025%
• Frequency Response(typical): 20 Hz-20 kHz, 0/-1 dB @ 1 watt
• Damping Factor: greater than 200
• Dynamic Headroom: 2 dB at 8 ohms
• Input Impedance:10 K ohms unbalanced, 20 K ohms balanced
• Controls: Front: AC Switch, AC Circuit Breaker
Back: Stereo/Bridge Switch, Ch 1 and Ch 2 Gain Knobs 8 Position DIP Switch for Filter and Limiter
• Indicators: POWER: Green LED, CLIP: Red LED, 1 per channel
• Connectors (each channel): Input: Barrier strip and Neutrik Combo 1/4 inch TRS and XLR, tip and pin 2 positive, Speakers: Touch-proof binding posts
• Amplifier Protection: Full short circuit, open circuit, thermal, ultrasonic, and protection. Stable into reactive or mismatched loads.
• Load Protection: On/off muting, DC-fault power protection
• Output Circuit Type: Class AB complementary linear outputs
• Power Requirements: 100, 120, 240 VAC, 50-60 Hz
• Dimensions: 19 inch (48.3 cm) rack mounting, 5.25 inch (13.3 cm)tall (3 rack spaces), 9.5 inch (24.1 cm) deep

California Prop 65 - WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov